Skylark V6-3100 3.1L VIN M SFI (1996)
Thermostat: Service and Repair
Removal Procedure
Notice: When adding coolant, use DEX-COOL® coolant. If silicated coolant is added to the system, premature engine, heater core or radiator
corrosion may result. In addition, the engine coolant will require change sooner-at 50 000 km (30,000 mi) or 24 months.
1. Disconnect the negative battery cable.
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF
before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in
contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its
components.
2. Drain the coolant to a level below the thermostat. Recover the coolant.
3. Remove the air inlet to the throttle body.
4. Disconnect the surge tank inlet pipe from the thermostat housing.
5. If the coolant outlet is being replaced, disconnect the radiator inlet hose from the coolant outlet.
6. Remove the 2 bolts from the coolant outlet.
7. Remove the coolant outlet.
