Skylark V6-3100 3.1L VIN M SFI (1996)
Tighten the bolts to 25 Nm (18 lb ft).
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners
requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use
paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint
clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid
damage to parts and systems.
4. Install the radiator inlet hose to the coolant outlet, if the hose was removed.
5. Install the surge tank inlet pipe to the thermostat housing.
6. Install the air inlet to the throttle body.
7. Refill the coolant.
8. Connect the negative battery cable.
Tighten
Tighten the negative battery cable bolt to 15 Nm (11 lb ft).
9. Start the engine. After the engine reaches normal operating temperature, check for coolant leaks.
