Skylark V6-3100 3.1L VIN M SFI (1996)
Important: Retain the washers in the same orientation on the center bolts.
26. Remove the lower intake manifold bolts.
27. Remove the lower intake manifold.
28. Remove the rocker arms and pushrods.
Installation Procedure
1. Place a 2-3 mm bead of GM RTV sealer P/N 1052917, or equivalent on each ridge where the front and the rear of the intake manifold contact the
block.
2. Install the intake manifold gasket.
3. Install the pushrods and rocker arms.
4. Install the lower intake manifold.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners
requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use