Skylark V6-3100 3.1L VIN M SFI (1996)
EN-48672 rear Main Oil Seal Remover Tool
This tool has a unique design to allow the technician to easily remove the rear main seal without nicking the crankshaft sealing surface when removing
the seal. Before proceeding with removal, review the above illustration to become familiar with the following components:
Removal Plate
Threaded Adjustment Pins and Jam Nuts
Force Screw
# 2 Self Drill Screws 38 mm (1.5 in) long 8 needed
Extreme Pressure Lubricant
Removal Procedure
Remove the transmission. Refer to Transmission Replacement in SI or the appropriate Service Manual.
Remove the engine flywheel. Refer to Engine Flywheel Replacement in SI or the appropriate Service Manual.
Install the removal plate (2) and both threaded adjustment pins and jam nuts (1) into the back of the crankshaft flange and secure the plate with
adjustment pins and jam nuts.
