Skylark V6-3100 3.1L VIN M SFI (1996)
Blower Motor: Initial Inspection and Diagnostic Overview
Troubleshooting Hints
PERFORM BEFORE BEGINNING SYSTEM DIAGNOSIS
1. If the Blower Motor does not operate, check the HVAC BLO MOT Fuse and the HTR-A/C Fuse.
2. If the Blower Motor does not operate:
-
Check that grounds G100 and G111 are clean and tight.
-
Check for a broken (or partially broken) wire inside of the insulation which could cause system failure but prove "GOOD" in a
continuity/voltage check
(See Diagnostic Aids for General Troubleshooting Procedures). See: Diagrams/Diagnostic Aids
^
Check for proper installation of aftermarket electronic equipment which may affect the integrity of other systems
(See Diagnostic Aids for General Troubleshooting Procedures). See: Diagrams/Diagnostic Aids