Skylark V6-3100 3.1L VIN M SFI (1996)
Shaft Key, Clutch Plate/Hub Installation
Installing Clutch Pate & Hub Assembly
Install or Connect
1. Install the shaft key into the hub key groove. Allow the key to project approximately 3.2 mm (1/8") out of the key way. The shaft key is curved
slightly to provide an interference fit in the hub key groove.
2. Be sure the frictional surface of the clutch plate and the clutch rotor are clean before installing the clutch plate and hub assembly.
3. Align the shaft key with the shaft keyway and place the clutch plate and the hub assembly onto the compressor shaft.
NOTICE: Do not drive or pound on the clutch hub or shaft. Internal damage to compressor may result.
4. Remove the J 33013-B remover-installer center screw and reverse the body direction on the center screw as shown in the illustration.
5. Install the clutch plate and hub installer J 33013-B with bearing as shown in the illustration.
The body of the J 33013-B installer should be backed off sufficiently to allow the center screw to be threaded onto the end of the compressor shaft.
6. Hold the center screw with a wrench. Tighten the hex portion of the installer J 33013-B body to press the hub onto the shaft. Tighten the body
several turns, remove the installer and check to see that the shaft key is still in place in the keyway before installing the clutch plate and hub
assembly to its final position. The air gap between frictional surfaces of the clutch plate and clutch rotor should be 0.40-0.50mm (0.015-0.020").
