Skylark V6-3100 3.1L VIN M SFI (1996)
selection and verification, refer to your paint manufacturer's color book. On wheels that were previous clearcoated aluminum it is recommended that all
four wheels and their center caps be refinished to maintain color uniformity.
Important:
THE PRODUCTS LISTED MUST BE USED AS A SYSTEM. DO NOT MIX OTHER MANUFACTURERS' PRODUCT LINES WITH THE
REQUIRED MATERIALS. PRODUCTS LISTED IN THIS BULLETIN HAVE SHOWN THE REQUIRED REPAIR DURABILITY, AND
CURRENTLY ARE THE ONLY PAINT SYSTEMS THAT MEET GM SPECIFICATION 4350M-A336.
Procedures
1.
Remove wheels from vehicle. Tires may remain mounted on wheels.
2.
Remove balance weights and mark their location on tire.
3.
Wipe excess grease, etc. from wheels with wax and grease remover.
4.
Have wheels plastic media blasted to remove clearcoat. FOR FURTHER INFORMATION ON MEDIA BLASTING IN YOUR AREA, CALL US
TECHNOLOGIES INC., CONTACT DAVE ROSENBURG AT 1-800-634-9185.
Caution:
IT IS MANDATORY THAT ADEQUATE RESPIRATORY PROTECTION BE WORN. EXAMPLES OF SUCH PROTECTION ARE: AIR
LINE RESPIRATORS WITH FULL HOOD OR HALF MASK. IF NOT AVAILABLE, USE A VAPOR/PARTICULATE RESPIRATOR
THAT RESPIRATOR MANUFACTURER RECOMMENDS AS EFFECTIVE FOR ISOCYANATE VAPOR AND MISTS (UNLESS
LOCAL REGULATIONS PREVAIL).
5.
Painting Process
a.
Refer to Attachments 1-3 for each System's individual formula and process.
b.
After following the specific System's individual formula and process, follow these steps:
6.
Unmask wheels.
7.
Clean all wheel mounting surface of any corrosion, overspray, or dirt.
8.
Install new coated balance weights, at marked locations.
9.
Replace wheels on vehicle.
10.
USE A TORQUE STICK ON AN IMPACT WRENCH, OR A TORQUE WRENCH TO CONSISTENTLY AND UNIFORMLY FASTEN THE
WHEEL TO THE SPECIFIED TORQUE FOR THE VEHICLE. THE STAR PATTERN MUST BE FOLLOWED.
Important:
TORQUE STICKS MUST BE USED ANY TIME AN IMPACT WRENCH IS USED TO TIGHTEN WHEEL NUTS.
Warranty Information
For vehicles repaired under warranty, use as shown.
