buick Workshop Repair Guides

Buick Workshop Service and Repair Manuals

ABOUT US
Quad Driver <--> [Output Driver] > < Splicing Copper Wire Using Crimp and Seal Splice Sleeves|Page 6779

Skylark V6-3100 3.1L VIN M SFI (1996)

Page 1
background image

Manifold Absolute Pressure (MAP) Sensor: Service and Repair

MAP Sensor Service

REMOVE OR DISCONNECT

1. Disconnect the negative battery cable.
2. Remove the bolts / screws (2)
3. Remove the electrical connector.
4. Remove the inlet vacuum hose.
5. Remove the MAP sensor from the bracket

INSTALL OR CONNECT

1. Installation the inlet vacuum hose.
2. Connect the electrical connector.
3. Position the MAP sensor to bracket and drive bolt/screws (2) securely seated and not stripped.
4. Connect the negative battery cable.

Quad Driver <--> [Output Driver] > < Splicing Copper Wire Using Crimp and Seal Splice Sleeves|Page 6779