Skylark V6-3100 3.1L VIN M SFI (1996)
Fuel Tank Unit: Service and Repair
Fuel Level Sensor Replacement
REMOVE OR DISCONNECT
1. Relieve fuel system pressure.
2. Drain fuel tank.
3. Remove the fuel tank.
4. Remove the fuel sender assembly.
5. Remove the bumper from modular fuel sender assembly.
6. Remove the fuel level sensor (1) from modular fuel sender.
INSTALL OR CONNECT
1. Fuel level sensor to modular fuel sender.
2. Install the bumper to modular fuel sender assembly.
3. Install the fuel sender assembly.
4. Install the fuel tank.
5. Refill tank.
6. Inspect for fuel leaks through the following steps:
-
Turn the ignition to the ON position for two seconds
-
Turn the ignition to the OFF position for ten seconds.
-
Turn the ignition to the ON position
-
Check for fuel leaks.