Skylark V6-3100 3.1L VIN M SFI (1996)
Camshaft Position Sensor: Service and Repair
REMOVE OR DISCONNECT
1. Disconnect the negative battery cable.
2. Remove the serpentine drive belt.
3. Remove power steering pump assembly.
4. Remove the electrical connector.
5. Remove the bolt.
6. Remove the sensor.
INSTALL OR CONNECT
1. Install the Camshaft Position Sensor.
-
Tighten the retaining bolt to 10 Nm (8 lb. ft.).
2. Install the electrical Connector
3. Install the power steering pump.
4. Install the serpentine drive belt.
