Skylark V6-3100 3.1L VIN M SFI (1996)
PROM - Programmable Read Only Memory: All Technical Service Bulletins
SPS/EEPROM - Programming Chart
File In Section: 6E - Engine Fuel & Emission
Bulletin No.: 53-65-05
Date: October, 1995
Subject:
Chart to Assist Technician with SPS/EEPROM Programming
Models:
1995-96 Passenger Cars and Trucks
This bulletin is being issued to assist technicians with the reprogramming of vehicles. The following chart was developed to be used by technicians that
are familiar with the Techline terminals, Tech 1 and all of its adapters:
IMPORTANT
If programming a new control module, you must request information from the new control module first.
Battery voltage must be between 11 and 14 volts. System to be programmed should NOT be connected to a battery charger. Incorrect voltage could
cause programming and/or control module failure.
