Skylark V6-3100 3.1L VIN M SFI (1996)
CAMSHAFT POSITION SENSOR
STEPPER MOTOR CRUISE CONTROL STATUS INPUT
The stepper motor cruise control module sends the cruise status input to the PCM to indicate when cruise control is engaged. The PCM monitors
the cruise status signal while commanding cruise to be disengaged via the cruise inhibit circuit. Any of the following conditions may cause the
PCM to inhibit cruise control operation:
^
Engine not running long enough for cruise control operation.
^
Transaxle range inputs indicate park, neutral, low, or reverse gear selected.
^
Engine speed is too high or too low.
^
Vehicle speed is too high or too low.
^
ABS system is active for longer than 2 seconds.
^
Vehicle acceleration or deceleration rate is too high.
ENGINE OIL LEVEL SENSOR
The PCM monitors the Engine Oil Level Sensor signal at startup to determine if engine oil level is OK. If the PCM determines that a low oil level
condition exists, the PCM will illuminate the "Low Oil Level" indicator lamp.
