Skylark V6-3100 3.1L VIN M SFI (1996)
2.
There should be a 180 clockwise twist between the guide loop and the rocker on the driver's side. Refer to Figure 1 and 2.
3.
There should be a 180 counter clockwise twist between the guide loop and the rocker on the passenger side. Refer to Figures 1 and 2.
4.
The latch plate should face to the outside of the vehicle if the belt is held without a twist from the guide loop to the latch.
5.
If the belt or the latch are not positioned as described in Steps 1 through 4, corrections should be made without removing any part of the seat belt
system.
^
If the seat belt assembly is the old part number as listed below, replace both the right and left seat belt assembly with the new part number.
Refer to Section 10-11 in the Service Manual for remove and install procedures.
Parts Information