Skylark V6-3100 3.1L VIN M SFI (1996)
Generator Not Operating Properly
The charts shown can be used in place of the diagnostic procedures in previous Service Manuals when this new tool is used. This information will be
included in the 1999 Service Manual.
Inspect the following before testing the generator:
^
The battery. Make sure the vehicle battery is in good condition and fully charged. Refer to Battery Load Test.
^
The built in hydrometer in the battery. The green eye must be showing in the hydrometer.
^
The voltage across the battery terminals with all the loads OFF should be above 12 V. Refer to Battery Load Test.
^
Make sure the battery connections are clean and tight.
^
The drive belt for damage or looseness.
^
The wiring harness at the generator. Make sure the harness connector is tight and latched. Make sure the output terminal of the generator is connected
to the vehicle battery (positive) generator lead.
^
All the charging system related fuses and electrical connections for damage or looseness. Refer to the starter and charging system schematics.
