Skylark V6-3100 3.1L VIN M SFI (1996)
1.
Move wheel and tire from vehicle.
2.
Move the piston into the caliper bore using a C-clamp (Kent-Moore tool # J 42588 or equivalent). Refer to Figure 1.
Notice:
Use care to avoid permanently bending the anti-rattle clips on the outboard brake pad, 5 mm (1/8 inch) is sufficient.
3.
Check the outer brake pad for freedom of movement relative to the knuckle abutment. Refer to Figure 2.
Important:
The brake pads must move easily within the knuckle.
