Somerset Regal L4-151 25L (1985) Rear Door Panel Removal & Replacement
Rear Door Panel: Technical Service Bulletins
Doors - Interior Trim Panel Removal & Replacement
Bulletin:
85-10-26A
Date:
Aug 1985
Ref. No.: 85-282A-10
SUBJECT:
INTERIOR DOOR TRIM PANEL REMOVAL AND REPLACEMENT
MODELS AFFECTED:
1985 SOMERSET
NOTE:
This bulletin supersedes 85-10-26 dated July, 1985, for text revision. Please discard original bulletin and replace it with this one.
Door trim panel retainers may become loose or separated from the formed door trim Panel foundation board. This may be due to removal of the door
trim panel when servicing the internal mechanism of the door without using the proper trim pad remover tool..
To prevent damage to the trim panel foundation board or retainer clip, trim pad remover tool J-24595B, BT-7323A or BT-7323B should be used. DO
NOT grasp trim panel and pull on board to disengage fasteners as described in the 1985 Body by Fisher Service Manual. Each fastener should be
disengaged using the trim pad remover tool.
Door Trim Panel
When a retainer clip is broken or separates from the door trim panel foundation board, it is NOT necessary to replace the door trim panel. It can be
re-attached using 3M Structual Adhesive, Part No. 8101 or equivalent. Epoxy must be allowed adequate time to cure prior to replacing trim panel on
door. The procedure in Section 5 N Style of the 1985 Fisher Body Service Manual should be followed. See illustration.