Somerset Regal L4-151 2.5L (1985)
Clinching Procedure ( Step 2 )
d. Position a ball peen hammer on outboard shoe tab, then using a larger brass hammer, lightly tap the ball peen hammer to bend the outboard
shoe tab. Tabs must be bent around casting to approximately 45°.
e. After both tabs have been bent, pressure should be released and the outboard shoe should be locked into position. If the shoe is loose, repeat
steps a. through d.
NOTE: If an outboard shoe is removed from the caliper, or the tabs unclinched for any reason, then it will be necessary to replace the shoe and
lining assemblies. Do not re-clinch outboard shoe locking tabs after having removed shoe from caliper.
.
With Tab Mount
Shoe And Lining Assembly
1.
Lubricated new bushings in grooves in mounting bolt holes and new sleeves in mounting bolt holes.
2.
Install retainer spring on inboard shoe.
Installing Inboard Shoe And Lining
3.
Install inboard shoe and lining.
