Somerset Regal L4-151 2.5L (1985)
Brake Caliper: Service and Repair
Removal
For additional informatin see Removal Notes. See: Fundamentals and Basics
1. Remove approximately 2/3 of brake fluid from master cylinder.
NOTE: Mark relationship of wheel to hub and bearing assembly, to insure proper wheel balance upon reassembly.
2. Raise and support front of vehicle, then remove wheel and tire assembly. Reinstall two wheel nuts to retain rotor to hub and bearing assembly.
Compressing Caliper Piston With Pliers
3. Position suitable pliers over inboard pad and housing and squeeze pliers to compress caliper piston.
NOTE: If only shoe and linings are being replaced, there is no need to disconnect inlet fitting.
CAUTION: Do not crimp brake hose, as this may damage internal structure of hose.