Somerset Regal L4-151 2.5L (1985)
Compressor Clutch Coil: Service and Repair
Delco Air DA-6 & Hr-6 Compressor
Removal
Fig. 3 Removing clutch coil assembly
1.
Refer to ``Compressor Clutch Rotor/Bearing'' procedure, steps 1-4 and remove pulley rotor and bearing assembly.
2.
Mark clutch coil terminal location on compressor front head.
3.
Install J-33023 puller pilot on front head of compressor. Install puller crossbar J-8433-1 with puller legs J-33025, Fig. 3.
4.
Tighten forcing screw J-8433-3 against puller pilot and remove clutch coil.
Installation
Fig. 4 Installing clutch coil assembly
1.
Position clutch coil assembly on front head with terminals located at mark.
2.
Place clutch coil installer J-33024 over internal opening of clutch coil housing and align installer and clutch coil with compressor front head.
3.
Center puller crossbar J-8433-1 in countersunk center hole of clutch coil installer J-33024. Install through bolts and washers J-33026-2 through
