Terraza AWD V6-3.5L VIN L (2006)
4. Install the outside handle cable to the lock assembly.
5. Install the lock assembly to the sliding door.
6. Install the sliding door handle lock actuator screws.
Tighten the screws to 10 N.m (89 lb in).
7. Connect the sliding door lock module harness connector, if equipped.
8. Push the lock rod towards the sliding door lock assembly and snap the barrel nut into the lock assembly.
9. Install the door lock module. Refer to Lock Module Replacement - Sliding Door ()
10. Install the control rods to the sliding door outside handle (1).
11. Inspect for proper lock rod travel.
12. Install the sliding door water deflector. Refer to Water Deflector Replacement - Sliding Door () .
13. Install the sliding door inner trim panel. Refer to Trim Panel Replacement - Side Rear Door () .
Important: By installing the 15A fuse, the low current logic power will be restored to both the LH and RH PSDMs and the PSDs will be
operational. However, both PSDMs will have to learn the full open and full closed positions of the PSD. Refer to Acutator Control
Module - Power Sliding Door (PSD) Programming and Setup.
14. If equipped with a power sliding door, enable the PSD system by installing the PSD 15A fuse into the I/P fuse block.