Terraza AWD V6-3.5L VIN L (2006)
1. Install NEW sealing washers onto the evaporator core.
2. Install the TXV to the evaporator core.
3. Install the TXV to evaporator bolts.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the bolts to 3.2 N.m (28 lb in).
4. Remove the caps or tape from the evaporator inlet and outlet tubes.
5. Install NEW sealing washers onto the inlet and outlet tubes.
6. Install the evaporator inlet tube to the outlet tube.
7. Connect the evaporator inlet and outlet tube block to the TXV.
8. Install the evaporator tube block to the TXV nut.
Tighten the bolts to 16 N.m (12 lb ft).
9. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging.
10. Leak test the fittings using the J 39400-A.
