Terraza FWD V6-3.5L VIN L (2006)
Rear Bumper Cover / Fascia: Service and Repair
Fascia Replacement - Rear Bumper (Pontiac)
Fascia Replacement - Rear Bumper (Pontiac)
Tools Required
J 38778 Door Trim Pad Clip Remover
Removal Procedure
1. Open the liftgate.
2. Disconnect the electrical connection (1) for the rear object sensor harness, if equipped.
3. Use the J 38778 in order to remove the push-in retainers (3) from the upper and lower rear bumper fascia.
4. Remove the screws (5) at the right and left wheel well from the rear bumper fascia.
5. Remove the palnut from the rear bumper fascia outer retainer.
6. Remove the rear bumper fascia (2) from the vehicle.
7. Remove the rear parking assist (RPA) sensors, if equipped. Refer to Rear Object Sensor Replacement.
8. Transfer the rear object sensors to the new rear bumper fascia, if equipped.
Installation Procedure
1. Install the RPA sensor to the rear bumper fascia, if equipped. Refer to Rear Object Sensor Replacement.