Terraza FWD V6-3.5L VIN L (2006)
Power Sliding Door Release Actuator: Service and Repair
Lock Actuator Replacement - Power Sliding Door
LOCK ACTUATOR REPLACEMENT - POWER SLIDING DOOR
REMOVAL PROCEDURE
1. If equipped with a power sliding door, disable the PSD system by removing the PSD 15A fuse from the instrument panel (I/P) fuse block.
IMPORTANT: By removing the power sliding door (PSD) 15A fuse, the low current logic power for both the LH and RH power sliding door
modules (PSDM) will be interrupted and both PSDs will be inoperative.
2. Remove the sliding door inner trim panel.
3. Remove the sliding door water deflector.
4. Remove the sliding door lock module.
5. Disconnect the power sliding door latch release actuator electrical connector.
6. Remove the power sliding door latch release actuator rivets.
7. Remove the power sliding door latch release actuator.
8. Unhook the power sliding door latch release actuator rod from the power sliding door latch release actuator.
INSTALLATION PROCEDURE
1. Install the power sliding door latch release actuator rod to the power sliding door latch release actuator.
2. Position the power sliding door latch release actuator to the power sliding door.
3. Install the power sliding door latch release actuator rivets.
4. Secure the rivets.
5. Secure the actuator to the lock rod.
6. Install the sliding door lock module.
7. Install the sliding door water deflector.
8. Install the sliding door inner trim panel.
9. If equipped with a power sliding door, enable the PSD system by installing the PSD 15A fuse into the I/P fuse block.
IMPORTANT: By installing the 15A fuse, the low current logic power will be restored to both the LH and RH PSDMs and the PSDs will be
operational. However, both PSDMs will have to learn the full open and full closed positions of the PSD. Refer to Actuator Control Module - Power
Sliding Door (PSD) Programming and Setup.