Terraza FWD V6-3.5L VIN L (2006)
Remove the coolant inlet and outlet hoses/pipes from the engine pipes and the throttle body studs.
Remove the coolant inlet and outlet hoses/pipes from the vehicle. Discard the old coolant hoses/pipes assembly.
Remove the two lower throttle body studs from the upper intake manifold and discard.
Replace the coolant inlet and outlet hoses/pipes with the revised part number listed below:
All 2006 models listed in this bulletin use two 10 mm (0.4 in) longer throttle body studs, P/N 11562429.
Replace the throttle body studs with longer 10 mm (0.4 in) studs. Refer to revised part numbers shown.
Tighten
Tighten the two studs to 6 N.m 53 lb in)
Install the revised coolant inlet and outlet hoses/pipes assembly.
Install the coolant inlet and outlet hoses/pipes clamp nuts to the throttle body studs.
Tighten
Tighten the nuts to 10 N.m (89 lb in).