chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Body and Frame|Bumper > < Assist Step Front Extension Replacement|Page 9487
Page 21
background image

*

Check the height and the alignment to the rocker panel. 

*

Check the height and the alignment to the rocker panel cladding and to the body. If the vehicle is equipped with assist steps, the
cladding will be shorter across the bottom.

1. Install the rear section of the assist step extension, align the rear edge of the assist step with the rear edge of the retainer and pushing downward

until fully seated.

Notice:  Refer to Fastener Notice   in Cautions and Notices.

2. Install the screw to the left rear outer edge of the assist step extension. Lift upward on the assist step until fully released from the retainer.

   Tighten the screw to the left rear outer edge of the assist step extension to 2 Nm (18 lb.in.).

3. Install the screws to the right rear inner and outer wheel well. Open the sliding door to expose the screw. Lift upward on the assist step extension

until fully released from the retainer

   Tighten the screws to the right rear inner and outer wheel well to 2 Nm (18 lb.in.).

4. Install the front section of the assist step extension. Refer to Assist Step Plate Replacement   (See: Assist Step Plate Replacement).
5. Lower the vehicle.

Body and Frame|Bumper > < Assist Step Front Extension Replacement|Page 9487