chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Trunk / Liftgate Striker > < Liftgate Strut Ball Stud Replacement|Page 9767
Page 2
background image

2. If equipped with a rear defogger, install the following components:

1. The rear window defogger electrical connector to the harness
2. The grommet, fully to the body, in order to ensure that water can not enter
3. The body-side rear garnish molding and speaker as one unit

Refer to Third Pillar Trim Replacement - Left Side   (See: Interior Moulding / Trim/Trim Panel/Service and Repair/Third Pillar Trim
Replacement - Left Side) in Interior Trim.

4. The body-side rear garnish molding to the headliner

Refer to Fourth Pillar Trim Replacement - Left Side   (See: Interior Moulding / Trim/Trim Panel/Service and Repair/Fourth Pillar Trim
Replacement - Left Side) in Interior Trim.

3. Inspect the rear defogger operations.
4. Remove the prop and close the liftgate.
5. Inspect the rear defogger in order to verify that the component is operating correctly.

Trunk / Liftgate Striker > < Liftgate Strut Ball Stud Replacement|Page 9767