Astro Van 2WD V6-4.3L VIN W (2001)
1. Install the engine oil pressure gauge sensor fitting, if removed.
Tighten
1.1.
Tighten the engine oil pressure gauge sensor fitting to 15 N.m (11 lb ft).
IMPORTANT: Do not loosen the sensor fitting. Do not tighten the sensor fitting more than one turn to align.
1.2.
Tighten the sensor fitting until properly aligned.
2. Install the engine oil pressure gauge sensor.
3. Hold the engine oil pressure gauge sensor fitting with a wrench to prevent from turning.
Tighten
Using J 41712 tighten the engine oil pressure gauge sensor to 30 N.m (22 lb ft).
4. Install the engine oil pressure gauge sensor electrical connector.
5. Install the engine cover. Refer to Engine Cover Replacement in Interior Trim.
