Astro Van 2WD V6-4.3L VIN W (2001)
Accelerator Pedal: Service and Repair
ACCELERATOR CONTROLS PEDAL REPLACEMENT
REMOVAL PROCEDURE
1. Lift upward on the accelerator pedal (3) to relieve tension on the cable (2).
2. Remove the retainer (1) from the pedal lever (4) hole.
3. Remove cable (2) from the slot in the pedal lever (4).
4. Remove the accelerator pedal mounting fasteners.
5. Remove the accelerator pedal assembly.
INSTALLATION PROCEDURE
IMPORTANT: The accelerator cable is not to be kinked or damaged in any way during installation.
Ensure that the mounting surface between the accelerator pedal assembly and the dash panel is free of insulation. The carpet and padding in the pedal
area must be positioned to lay flat and be free of wrinkles and bunches. Wire, hoses, cables, and other flexible components should not be within 13
mm (0.52 in) of the cable or lever, at any point in their travel.
1. Place the accelerator pedal assembly on the mounting surface.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the three mounting bolts.
Tighten
Tighten the pedal assembly to 5 N.m (44 lb in).
