Astro Van 2WD V6-4.3L VIN W (2001)
Notice: Do not start the engine with any power steering hose disconnected, or damage to the components could occur.
1. Install the hydraulic brake booster inlet hose to vehicle.
2. Connect the hydraulic brake booster inlet hose to the hydraulic brake booster.
3. Raise the vehicle. Refer to Vehicle Lifting.
Notice: Refer to Fastener Notice in Service Precautions.
4. Connect the hydraulic brake booster inlet hose to the power steering pump.
-
Tighten the hydraulic brake booster inlet hose to the power steering pump to 27 Nm (20 ft. lbs.).
5. Bleed the system. Refer to Bleeding the Power Steering System.
