Astro Van 2WD V6-4.3L VIN W (2001)
9. Install but do not tighten the control valve body bolts which retain the transmission fluid pressure switch to the control valve body.
Notice:
^
Torque valve body bolts in a spiral pattern starting from the center. If the bolts are torqued at random, valve bores may be distorted and inhibit
valve operation.
^
Refer to Fastener Notice in Service Precautions.
10. Tighten the control valve body bolts in a spiral pattern starting from the center, as indicated by the arrows.
Tighten the control valve body bolts (in sequence) to 11 Nm (97 inch lbs.).
11. Ensure that the manual detent spring is aligned properly with the detent lever.
Tighten the manual detent spring bolt to 11 Nm (97 inch lbs.).
12. Install the TCC solenoid with a new O-ring seal to the valve body.
