Astro Van 2WD V6-4.3L VIN W (2001)
8. Slide the spider spacer ring (3) and the tripot spider assembly (2) up on the halfshaft bar (4). This will provide access to the halfshaft bar retaining
ring (1) which is in the groove at the end of the halfshaft bar (4).
9. Remove the retaining ring (1), spider assembly (2), spacer ring (3), and tripot boot (4).
10. Clean the halfshaft bar (5). Use a wire brush in order to remove any rust in the boot mounting area (grooves).
11. Inspect the needle rollers, needle bearings, and trunnion. Check the tripot housing for unusual wear, cracks, or other damage. Replace any
damaged parts.
Assembly Procedure
1. Place the new small boot clamp (2) onto the small end of the joint boot (1).
2. Slide the tripot boot (1) and small boot clamp (2) into the proper position on the halfshaft bar.
3. Position the small end of the joint boot (1) into the joint boot groove (3) on the halfshaft bar.
Notice: Refer to Fastener Notice in Service Precautions.
