Astro Van 2WD V6-4.3L VIN W (2001)
9. Push the spider assembly (1) back toward the end of the halfshaft bar (3) until the retaining ring is covered by the spider assembly counterbore.
10. Move the spider spacer ring (2) back toward the end of the halfshaft bar. Seat the spider spacer ring (2) in the spacer ring groove. Make sure the
spider spacer ring is fully seated.
11. Pack the tripot boot and the tripot housing with the grease supplied in the kit. The amount of grease supplied in this kit has been pre-measured for
this application.
12. Place the large retaining clamp (2) on the boot.
13. Place the housing (1) over the spider assembly (3).
14. Install the boot onto the housing (1).
15. Check the inboard stroke position.
