Astro Van 2WD V6-4.3L VIN W (2001)
Liftgate Window Glass: Service and Repair
Liftgate Window Replacement
Tools Required
*
J 24402-A Glass Sealant (Cold Knife) Remover
*
J 39032 Stationary Glass Removal Tool
*
Urethane Adhesive Kit GM P/N 12346392 or equivalent
*
Isopropyl alcohol or equivalent
*
Cartridge-type caulking gun
*
Commercial-type utility knife
*
Razor blade scraper
*
Suction cups
*
Plastic paddle
Removal Procedure
Important: Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces
and inner trim of the window.
1. Disconnect the washer hose from the liftgate.
2. Remove the back window wiper arm from the liftgate. Refer to Rear Window Wiper Arm Replacement in Wipers/Washer Systems.
3. Open liftgate window.
4. Remove the liftgate window garnish molding. Refer to Liftgate Garnish Molding Replacement () in Body Rear End.
5. Disconnect the electrical connector from the rear window defogger on the liftgate window.
Caution: When working with any type of glass or sheet metal with exposed or rough edges, wear approved safety glasses and gloves in order to
reduce the chance of personal injury.
6. Use safety glasses and gloves.
7. Using a sharp utility knife, make a preliminary cut around the perimeter of the rear window. Cut as close to edge of the rear window as possible.
