Astro Van L AWD V6-262 4.3L VIN Z (1994)
Brake Light Switch: Service and Repair
Fig. 15 Stop Lamp Switch Replacement.
The zero adjust stop lamp switch does not need adjustment because the switch is installed along with the brake push rod and held by a single
retainer.
1. Disconnect battery ground cable.
2. Disconnect stop lamp switch electrical connector.
3. Disconnect retainer from brake pedal pin, Fig. 15.
4. Remove stop lamp switch by unsnapping from pushrod.
5. To install switch, snap into pushrod.
6. Snap retainer onto brake pedal pin, then connect switch electrical connector.
7. Connect battery ground cable.
