Astro Van L AWD V6-262 4.3L VIN Z (1994)
dispose.
NOTICE: SIR coil assembly wire must be kept tight with no slack while installing SIR coil assembly. Failure to do so may cause wire to be kinked
near shaft lock area and cut when steering wheel is turned.
16. Ensure coil assembly (3) hub is centered.
17. Coil assembly (3).
a). Pull wires tight while positioning SIR coil to steering shaft.
b). Align opening in coil with horn tower and "locating bump" between two tabs on housing cover.
c). Seat coil assembly into steering column.
d). Connector shroud (5).
18. Coil assembly retaining ring (2). Ring (2) must be firmly seated in groove on shaft.
NOTICE: Gently pull lower coil assembly and turn signal harness to remove any wire kinks that may be inside steering column assembly. Failure to
do so may cause damage to wire harness.
19. Wiring protector (43).
20. Negative (-) battery cable.
21. If all service operations are completed, enable the SIR system.
Inspect
a). Function check turn signal switch (15).
b). Position switch lever to right turn position. Turn steering wheel to left. Switch should cancel to center position.
c). Repeat above procedure for left turn position.
d). If turn signal switch does not return to center position check switch (15) forbroken or missing cancel spring, or a worn or damaged cancel cam
(10).
