Astro Van M L4-151 2.5L (1985)
DRILL BE REVERSED PRIOR TO USING THE DRILL. ROTATION OF THE DRILL SHOULD BE
COUNTER-CLOCKWISE.
FIGURE 3
7.
Drill into the bolt approximately .60-.70 in. (15-18 mm) deep, see FIGURE 3. The drill may be marked in a similar manner as above for gauging
hole depth.
IMPORTANT:
USE CUTTING OIL AS NECESSARY DURING DRILLING.
8.
Remove tool J-38188-2 from the cylinder head.
9.
Using a slender rod or screwdriver and a hammer, apply a sharp impact to the bolt to help jar it loose. Blow debris from the hole.