Astro Van M V6-262 4.3L VIN Z (1994)
Compressor Clutch: Service and Repair
With HR100/HR110-MD Compressor
Clutch Plate and Hub Assembly
Remove or Disconnect
1. If compressor is on the vehicle, loosen compressor mounting brackets, disconnect the compressor drive belt and reposition the compressor for
access, if necessary.
Compressor In Holding Fixture
If compressor has been removed from the vehicle, attach the compressor to Holding Fixture J 25008-A and clamp the Holding Fixture in a vise.
^
Compressor mounting holes are metric. Use proper metric bolts with holding fixture J 25008-A.
Clutch Plate & Hub Assembly Removal
2. Thread the Clutch Plate and Hub Assembly Remover J 33013-B, into the hub. Hold the body of the Remover with a wrench and turn the center
screw into the Remover body to remove the Clutch Plate and Hub assembly.
3. Remove the shaft key.
Install or Connect