Avalanche 1500 2WD V8-5.3L (2008)
Tailgate Weatherstrip: Customer Interest
Body - Mid Gate Water Leak/Carpet Wet/Mildew Odor
TECHNICAL
Bulletin No.: 08-08-57-007C
Date: April 06, 2011
Subject: Midgate Water Leak (Align and Adjust Midgate Components)
Models:
2006-2012 Cadillac Escalade EXT
2006-2012 Chevrolet Avalanche
Supercede:
This bulletin is being revised to add the 2012 model year. Please discard Corporate Bulletin Number 08-08-57-007B (Section 08 - Body and
Accessories).
Condition
Some customers may comment on the following concerns:
-
The carpet is wet in the rear area of the vehicle.
-
There is condensation on the windshield or side glass.
-
There is a damp or mildew odor in the vehicle.
Cause
Important
Some vehicles may have been revised at the factory with the use of ribbon sealer in the area where the top bed rail seal joins the rear window
opening seal. It is important to maintain this revision during the repair procedures. If the revision material needs to be added to or replaced use
a 9.5 mm Butyl Ribbon Sealer, such as 3M P/N 08612 or equivalent. Refer to the opposite side of the repair vehicle to illustrate how the sealer is
applied.
-
Insufficient seal pressure between the upper midgate glass panel and the body opening weatherstrip.
-
Incorrect alignment of the midgate to the body.
-
Insufficient seal pressure between the tonneau or cargo cover and the midgate cross bar.
Water Test Procedure
1. Assure that the midgate cross bar is completely closed. Inspect the latches on both sides.
2. Assure that the arrow on the mid glass is aligned with the arrow on the cross bar.
3. Verify that the interior trim is not putting pressure on or overlapping the upper weatherstrip, causing a poor seal.
4. Ensure that the weatherstrip mucket (bat wing) is glued to the weatherstrip (1).
5. If the mucket is not glued as shown, use the following glue procedure.
-
Remove the weatherstrip as required to access this revision.