Avalanche 1500 2WD V8-5.3L (2008)
Turn Signal Switch: Service and Repair
Turn Signal Switch Cancel Cam Position Plate Replacement
Turn Signal Switch Cancel Cam Position Plate Replacement
Tools Required
*
J 23653-SIR Steering Column Lock Plate Compressor
*
J 42137 Cam Orientation Plate Adapter
Removal Procedure
1. Remove the inflatable restraint steering wheel module coil and the inflatable restraint steering wheel module coil wave washer. Refer to Inflatable
Restraint Steering Wheel Module Coil Replacement .
Important: DISCARD the old steering shaft lock plate ring.
2. Remove the following parts from the steering shaft:
1. Steering shaft lock plate retaining ring (1) using compressor J 23653-SIR and adapter J 42137 .
2. Turn signal switch cancel cam position plate (2)
3. Turn signal switch cancel cam (3)
Installation Procedure