Avalanche 1500 2WD V8-5.3L VIN Z Flex Fuel (2005)
9. Install the cable to the mounting bracket until the locking tabs snap into place.
10. Bolt the cable to the differential (clips).
^
Tighten the bolt to 25 N.m (18 lb ft).
Notice: Refer to Fastener Notice in Cautions and Notices.
Important: After installing the cable to the rear axle holding clip, verify that clip is securely retaining the cable. If not, crimp the clip by hand
taking care not to pinch or kink the cable.
11. Install the cable to the differential clip.
12. If vehicle is a 1500 series with the second design or a 2500 series, install the park brake cable to the equalizer bar by pulling down on the cable in
front of the equalizer and installing the cable to the equalizer bar.
