Avalanche 2500 4WD V8-8.1L VIN G (2003)
2. Install the encoder motor.
Rotate the shift detent lever to align to the encoder motor.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install encoder motor bolts.
Tighten the bolts to 10 Nm (89 inch lbs.).
4. Connect the encoder motor electrical connector (2).
5. Install the front propeller shaft.
6. Install the transfer case shield, if equipped.
Transfer Case Shift Control Switch Replacement
Transfer Case Shift Control Switch Replacement
Removal Procedure
1. Remove the instrument panel (I/P) cluster bezel.