Aveo L4-1.6L (2008)
Use the appropriate terminal and follow the instructions in the J-38125.
Connector Position Assurance Locks
Connector Position Assurance Locks
The connector position assurance (CPA) is a small plastic insert that fits through the locking tabs of all the SIR system electrical connectors. The CPA
ensures that the connector halves cannot vibrate apart. You must have the CPA in place in order to ensure good contact between the SIR mating
terminals.
Connector Repairs
Connector Repairs
The Connector Repairs section contains the following types of connector repair information. Using these elements together will make connector repair
faster and easier:
*
Connector Position Assurance Locks (See: Testing and Inspection/Component Tests and General Diagnostics)
*
Terminal Position Assurance Locks (See: Testing and Inspection/Component Tests and General Diagnostics)
*
Push to Seat Connectors (See: Testing and Inspection/Component Tests and General Diagnostics)
*
Pull to Seat Connectors (See: Testing and Inspection/Component Tests and General Diagnostics)
*
Weather Pack Connectors (See: Testing and Inspection/Component Tests and General Diagnostics)
*
Repairing Connector Terminals (See: Testing and Inspection/Component Tests and General Diagnostics)
Delphi Connectors (Micro .64)
Delphi Connectors (Micro.64)
Tools Required
J-38125 Terminal Repair Kit
Removal Procedure
Follow the steps below in order to remove terminals from Micro.64 connectors.
1. Locate the lever lock on the wire dress cover. While depressing the lock, pull the lever over and past the lock. The lever lock may be located on
the top or sides of the wire dress cover.
