Aveo L4-1.6L (2008)
Disclaimer
Correction
Correction
Notice
-
DO NOT perform the procedures outlined in this bulletin unless the vehicle has recently exhibited a P1516, P2106 and/or P2110 set in extremely
low ambient temperatures.
-
DO NOT perform the procedures outlined in this bulletin on new in-stock vehicles that have not exhibited the concern referenced in this bulletin.
-
DO NOT perform the procedures outlined in this bulletin as an attempt to repair other TPS or APP-related codes not listed in this bulletin. Follow
the appropriate SI diagnostic procedures for codes not listed in this bulletin.
If the vehicle has recently exhibited a P1516, P2106 and/or P2110 set in Extremely Low Ambient Temperatures, perform the steps outlined in this
bulletin to install the PCV valve kit and reprogram the ECM.
PCV Valve Kit Components
1. Air Outlet Duct Assembly
Throttle Body Adapter Assembly
2. Crankcase Breather and PCV Valve Hose Insulators
1. PCV Valve Hose, Insulator size 60 mm x 100mm (2.4 in x 3.9 in)
2. Breather Hose Right Side of PCV Valve, Insulator size 80 mm x 130 mm (3.1 in x 5.1 in)
3. Breather Hose Left Side of PCV Valve, Insulator size 130 mm x 145 mm (5.1 in x 5.7 in)
3. Map Sensor Vacuum Tube, Throttle Body Adapter Hose and Intake Manifold Vacuum Plug
1. Map Sensor Vacuum Tube Assembly
2. PCV Valve to Throttle Body Adapter Hose
3. Intake Manifold Vacuum Hole Plug
4. Left and Right Side Crankcase Breather hose Insulator Tie-Straps (Qty 6)
Important
Discard the two white tie-straps provided in the kit. Use only two of the new tie-straps, and retain the extra tie-straps for the next PCV
Valve Kit to be installed.
5. PCV Valve Hose Insulator Tie-Straps (Qty10), are Not part of the kit.
6. Engine Shackle Bracket
7. Map Sensor Bracket
Map Sensor Bracket Bolt/Screw
8. Throttle Body and Adapter Bolts/Screws
1. Allen Head Bolt/Screws Adapter to Intake Manifold (4)
2. Throttle Body to Adapter Bolts/Screws (4)
