Aveo L4-1.6L (2008)
Connect the throttle body assembly harness connector (2)
Important
Block the coolant hoses at the thermostat housing to prevent any leaks.
15. Remove the spring clamp and the upper radiator hose from the thermostat housing (2).
1. Remove and discard the throttle body heater coolant inlet hose assembly from the thermostat housing (1) and connect a new throttle body
heater coolant inlet hose assembly to the thermostat housing by using a pair of long nose pliers to remove and install spring clamp.
2. Position the new coolant inlet hose assembly on top of the timing belt cover in place of the old one (1).
3. Install the spring clamp and the upper radiator hose to the thermostat housing (2)
16. Install the spring clamp with the new coolant inlet hose assembly to the back or cowl side of the throttle body assembly (1). Make sure that the
new coolant inlet hose assembly is positioned under the power steering hose (2).
17. Removed in Step 5.5 was the PCV valve heater with attached hoses. The following hoses and spring clamps will need to be removed and re-used:
1. Throttle body short coolant inlet hose to PCV valve (1).
2. PCV valve coolant outlet hose to the surge tank (2).
