Blazer 4WD V6-4.3L VIN X (2005)
Air Door Actuator / Motor: Service and Repair
Air Temperature Actuator
AIR TEMPERATURE ACTUATOR REPLACEMENT
REMOVAL PROCEDURE
The air temperature actuator is located on the top right hand side of the HVAC module.
1. Remove the instrument panel carrier.
2. Disconnect the electrical connector (2).
3. Remove the air temperature actuator retaining screws.
4. Remove the air temperature actuator from the HVAC module.
INSTALLATION PROCEDURE
1. Install the air temperature actuator to the HVAC module. Ensure that the actuator is seated on the locating tab.
2. Install the air temperature actuator retaining screws.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 1.9 N.m (17 lb ft).
3. Connect the electrical connector (2).
4. Install the instrument panel carrier.