Blazer 4WD V6-4.3L VIN X (2005)
Cruise Control Module: Service and Repair
CRUISE CONTROL MODULE REPLACEMENT
REMOVAL PROCEDURE
1. Disconnect the battery negative cable.
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
2. Disconnect the cruise control cable. Refer to Cruise Control Cable Replacement (LU3).
3. Disconnect the electrical connector.
4. Remove the 3 nuts that retain the cruise control module to the mounting bracket studs.
5. Remove the cruise control module from the mounting bracket.
6. Remove the 3 screws that retain the mounting bracket to the cowl panel.
INSTALLATION PROCEDURE
1. Install the mounting bracket to the cowl panel with the 3 screws.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the cruise control module bracket screws to 4.5 N.m (40 lb in).
2. Install the cruise control module to the vehicle.
3. Install the 3 nuts that retain the cruise control module to the mounting bracket.
Tighten the cruise control module nuts to 9.0 N.m (6.6 lb ft).
4. Connect the electrical connector.
5. Install the cruise control cable. Refer to Cruise Control Cable Replacement (LU3).
6. Connect the battery negative cable.
7. Test the systems operation.