Blazer 4WD V6-4.3L VIN X (2005)
Wheel Fastener: Service and Repair
Rear Suspension
Wheel Stud Replacement
^
Tools Required
-
J 43631 Ball Joint Separator
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel assembly.
3. Remove the rotor.
4. Remove the wheel stud from the axle flange using the J43631.
Installation Procedure
1. Install the stud into the axle flange.
2. Install the 4 washers and the lug nut to the stud.
3. Tighten the lug nut in order to draw the stud into the flange until the stud fully seats.
4. Remove the lug nut and the washers.
5. Install the rotor.
6. Install the tire and wheel assembly.
7. Lower the vehicle.