Blazer 4WD V6-4.3L VIN X (2005)
Seals and Gaskets: Service and Repair
Transmission Housing Oil Seal Replacement - Front
Transmission Housing Oil Seal Replacement - Front
^
Tools Required
-
J 38801 Input Seal Installer
Removal Procedure
1. Remove the transmission.
2. Remove the 2 clutch actuator bolts.
3. Remove the clutch actuator from the input shaft.
4. Remove the 6 bolts from the front bearing retainer. Carefully remove the front bearing retainer.
5. Remove the seal from the front bearing retainer by using a hammer and a punch.
6. Remove the old gasket material from the front bearing retainer.