Blazer 4WD V6-4.3L VIN X (2005)
3. Remove the rear propeller shaft from the transfer case.
4. Remove the transfer case rear output shaft seal.
5. Inspect the rear output shaft bushing for scoring or wear.
6. Remove the rear output shaft bushings if required, using the J 45380.
^
Install the finger section of the J 45380 in front of the bushing.
^
Install the tube and forcing screw to the finger section. Ensure the forcing screw is backed out.
^
Using a wrench on the forcing screw, remove the rear output shaft bushing.
Installation Procedure
1. Install a NEW rear output shaft bushing, if required, using the J 45380.
^
Install the bushing or the finger section of the J 45380.
^
Install the finger section to the main body of the J 45380.
^
Position the bushing and tool to the case.
^
Using a hammer and the J 45380, install the bushing.
