C 1500 Suburban 2WD V8-393 6.5L DSL Turbo VIN S (1996)
Throttle Valve Cable/Linkage: Adjustments
1. Stop engine.
2. Remove cruise control rod if equipped.
3. Disconnect transmission throttle cable terminal from throttle assembly.
4. Loosen locknut on pump rod and shorten several turns.
5. Turn lever assembly to full throttle position and hold.
6. Lengthen pump rod until injection pump lever contacts full throttle stop.
7. Release lever assembly and tighten pump rod locknut.
8. Remove pump rod from lever assembly.
9. Reconnect transmission throttle cable terminal to throttle assembly.
Fig. 11 TV Cable Adjustment.
10. Depress and hold metal readjust tab on upper end of cable, Fig. 11, and move slider through fitting, away from lever assembly, until slider stops
against fitting.
11. Release tab, turn lever assembly to full throttle stop, and release lever assembly.
12. Reconnect pump rod, and cruise control throttle rod, if equipped.
13. If equipped with cruise control, adjust servo throttle rod to minimum slack (engine off).
